Important
The Water Tester is also suitable for saltwater pools/salt electrolysis pools!
It is important to clean the device after each measurement to get rid of any reagent residues! Please ensure that the cuvette has been cleaned before each measurement (e.g. under clear water/or simply rinsing the cuvette in the pool is sufficient as long as no residues remain). Do NOT use any cleaning agents!
The "ZERO" step is only necessary once after switching on. Make sure that the water to be measured does not (!) contain any tablet/reagent in the cuvette and that the light protection cover is in place. Please always perform “ZERO” step with the pool water to be measured. You can also perform another “ZERO” before each new measurement (display shows "TEST") (fill cuvettes with pool water, put on light protection cap, press “ZERO” button).
OR = Overrange
UR = Underrange.
Test result is outside the range of this method. OR results can be brought into
measurement range by dilution. Use syringe to take only 5 ml sample water
plus 5 ml distilled water. Test again and multiply results times 2.
Dilution does not work with „pH“ measurement.